|
|
Post by Kingrat on May 8, 2006 9:48:58 GMT -5
What kind of results do you usually get out of these canfield heads with your usual stage 3/4/5 work? I would like to keep the runners around 215cc or so at most and am hoping for 270+cfm at a usable lift and 290+ peak at .600-.650, hope you can easily best that  . |
|
85Iroc
Junior Member
Posts: 99
|
Post by 85Iroc on May 8, 2006 9:58:03 GMT -5
Mike did mine up with his full port job and they went 301 @ .600, 308 @ .700 & 312 @ .800 and exhuast in the 215-218 range from .600 on without a pipe. I picked up 7 mph in the 1/8th on a 355 and he said the intake runners were in the 212cc range. Hope this helps.
|
|
|
|
Post by Mike Stark on May 11, 2006 19:10:48 GMT -5
Chuck said it all. It's a good head and work really well.
|
|
|
|
Post by SO on Sept 5, 2006 7:00:48 GMT -5
Sounds very similar to mine. They began at 197cc and ended up at 215cc. Flow was 305. Mine will go on a 331" very soon and I'm looking to make 650+ with them using one 750 carb. Using titanium intakes/exhausts and a Jesel shaft system. They make a nice cylinder head IMO...
|
|
.
