Trick Flow SBC

BillsCamino
New Member

Posts: 5

Trick Flow SBC Jan 26, 2005 20:43:45 GMT -5

Quote

Post by BillsCamino on Jan 26, 2005 20:43:45 GMT -5

Hey Mike,
Can this be saved?
If so, when is a good time to call you to discuss this?

www.casemp.com/gregh/car/fubar3.JPG

Intake valve face snapped off the stem...slight P/V clearance issue...Trick Flow SBC 195cc, Duttweiler series.
Thanks!

Mike Stark Administrator Posts: 474	Trick Flow SBC Jan 27, 2005 13:09:15 GMT -5 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by Mike Stark on Jan 27, 2005 13:09:15 GMT -5 Yeah, it can be saved. It doesn't look that bad to me. Probably cost you about $300 to $350 total to weld it and freshen the set at the same time.

BillsCamino New Member Posts: 5	Trick Flow SBC Jan 27, 2005 22:31:45 GMT -5 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by BillsCamino on Jan 27, 2005 22:31:45 GMT -5 Sounds good Mike! I'll give you a call...

Post by BillsCamino on Jan 26, 2005 20:43:45 GMT -5

Post by Mike Stark on Jan 27, 2005 13:09:15 GMT -5

Post by BillsCamino on Jan 27, 2005 22:31:45 GMT -5

Quick Reply