Post by mike on Jul 22, 2004 21:54:41 GMT -5
I have a set of bowtie aluminum raised runner heads with titanium valves, jesel shaft rockers,bowtie intake manifold,roller lifters(offset .180) and a roller camshaft head studs and exhaust port plates(you dont have to use them.. This combo went 9.28 @144mph in my 2980lbs nova.. that is on the motor(no n20) The heads were done by headsup flow 341@.700 and 255exh. I just sold the rotating assembly(bryant crank,aluminum rods and light weight pistons) the motor was a 394 cu in. if you put this on a 380to420inch small block @3000lbs with 13to one compression you will go at least 9.50.. Dont waste your money on the 18 degree stuff they only flow about 10more cfm and you will have to change pistons and headers.. this is a complete top end minum carb(already sold it) 3500.00 obo takes it.. I spent 6500.00 for castings porting valves.. heads have never been damage and just need to clean up and bolt on.. valve springs have 20passes on them.. call if interested 909 415 5979.. if you want to see my honesty check my ebay status mikereese1 I have 100 percent positive feedback..
