canted valve heads

[chevyll]

I'm throw around the idea of building a new engine. I found a set of sbc canted valve brodix heads (cv sp 265).
Would it be possible to make 1000hp (on NOS)with this heads? I heard these heads have gasket issues, is this true? And are there any disadvantages to using these heads?
If you were to build a sbc with these heads, what cid,camshaft and compession would you use?

[Maximum Race Engines]

Yes it will be possible to make over 1,000 hp with these heads. Hvae not heard of gasket issues with the castings. Cubes? Min. 436, Compression? 13.1 minimum, Camshaft? big...Disadvantages, I would say cost, not just for the heads, but for all the parts needed with it. If the budget is there, then defnitely go with it.

[Mike Stark]

I have a complete canted valve motor for sale

406 that made 830 HP N/A and over 1100 with a single fogger.

Motor is complete carb to pan, vacuum pump to converter. It's yours for $12,500

Only 6 passes since last freshened.